HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

H (%)
This displays the threshold value for a pool.
raidcom add thp_pool
Creates a Pool for Thin Provisioning/Smart Tiers. Or, adds a pool volume. A device group can
also be specified instead of an LDEV.
When specifying a pool that is already created for Snapshot, the specified LDEV is added as a
pool volume.
Specify either one of pool ID or pool name certainly. If the specification of both pool ID and pool
name is omitted, it will be rejected with EX_REQARG.
This command is executed asynchronously with the command input. Check the completion of this
process on the raidcom get command_status command.
Syntax
raidcom add thp_pool {{-pool_id <pool ID#> [-pool_name <pool naming>] | -pool_name
<pool naming>[-pool_id <pool ID#>]} | -pool_id <pool ID#> -pool_name <pool naming>}
{-ldev_id <ldev#> …[-cnt <count>] | -grp_opt <group option> -device_grp_name <device group name>
[<device name>]}[ -user_threshold <%> ]
Options and parameters
DescriptionOption
Specifies a pool ID (0-127) for Thin Provisioning/Smart Tiers. When the specification of pool
ID is omitted, a pool name must be specified. When the pool name is specified and the pool
ID is omitted, a pool ID is allocated automatically.
-pool_id <pool ID#>
Specifies an pool name of a pool for Thin Provisioning/Smart Tiers. Up to 32 characters can
be specified.
-pool_name <pool
naming>
When the specification of pool name is omitted, a pool ID must be specified. When the pool
ID is specified and the pool name is omitted, a pool name is allocated automatically in the
form of “New Pool<number>”.
Specifies an LDEV number (0-65279). Up to 64 of LDEVs can be specified at a time.-ldev_id <ldev#> …
(e.g.)
• -ldev_id 100
• -ldev_id 100 - 110
• -ldev_id 100 -cnt 10
Specifies a count (2-64).[ -cnt <count> ]
The count becomes singular if not specified.
Up to 64 of LDEVs can be specified at a time.
Specifies the device information extracted from the LDEV belonging to the device group. Specify
“ldev” (fixed). The information of LDEV belonging to the device group is used.
-grp_opt <group
option>
Specifies the name of device group (max. 32 characters) to be operated.-device_grp_name
<device group name>
[<device name>]
To operate an LDEV in the device group, specify the device name of LDEV (max; 32 characters)
within the device group.
If the device name is omitted, all the LDEVs belonging in the device group are operated.
You may specify two user-defined thresholds, and their valid ranges are 1-100%, respectively.
If you specify <threshold_1> and <threshold_2>:
[ -user_threshold
<threshold_1>
[<threshold_2>] ]
The value of <threshold_1> is set as the threshold for WARNING specified to a pool.
The value of <threshold_2> is set as the threshold for High water mark specified to a pool.
If you specify only <threshold_1>, your specified value and the system default value (80%) are
applied. If you omit to specify the value, 70% and 80% are applied automatically.
178 Configuration setting commands