HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

-PNO
This displays the path number.
-MPORT
This displays the MCU port number.
-RPORT
This displays the RCU port number.
-STS_CD
This displays the following status of the path.
- NML_01: this means the status of “Normal” in path.
- ERR_02: this means the status of “Initialization Failed” in path.
- ERR_03: this means the status of “Communication timeout” in path.
- ERR_04: this means the status of “Logical Blockade” in path.
- ERR_05: this means the status of “Resource Shortage” in path.
- ERR_06: this means the status of “Serial Number Mismatch” in path.
- ERR_10: this means the status of “Invalid Port” in path.
- ERR_80: this means the status of “RCU Port Number Mismatch” in path.
- ERR_81: this means the status of “RCU Port Type Mismatch” in path.
- ERR_82: this means the status of “Communication Failed” in path.
-SSIDs
This displays the SSIDs (hexadecimal) setting to RCU.
If CU free is specified for RCU, "-" is displayed.
raidcom modify rcu
Sets the control parameters to CU that is specified using two way.
Syntax
raidcom modify rcu -cu_free <serial#> <id> <pid> -rcu_option <mpth> <rto> <rtt>
Options and parameters
DescriptionOption
-cu_free <serial#> <id> <pid>-cu_free <serial><id><pid>
This parameter is used to specify CU free that is specified by Serial#, id#, pid#.
< id > is used to set RAID Type, and it can be specified the following strings.
XP12000 Disk Array/XP10000 Disk Array:R500, XP24000/XP20000 Disk Array:R600,
P9500:R700
<pid> is used to set the path group ID (1-255).
This parameter is used to specify CU control parameters.-rcu_option <mpth> <rto>
<rtt>
<mpth> is used to set the number of path as minimum (1–8).
<rto> is used to set the timeout value (10–100) (second) for RIO (Remote IO) setting
between MCU and RCU.
<rtt> is used to set the round trip time value (1–500) (millisecond) between MCU and
RCU.
172 Configuration setting commands