HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

This displays VP Index, but this value is always zero currently.
FCF_I
This displays FCF Index, but this value is always zero currently.
raidcom modify port
Sets the attribute value of the specified port.
The specified port must be “TYPE=FIBRE and ATTR=TAR”, if not it will be rejected with EX_ENOOBJ.
When transmitting a fiber channel frame over Ethernet, this specifies the Port speed: 10G, Port
topology: f_port.
Syntax
raidcom modify port -port <port>{[-port_speed <value>] [-loop_id <value>]
[-topology <topology>] [-security_switch < y|n >] | -port_attribute <port attribute>}
Options and parameters
DescriptionOption
Specifies a port number.-port <port>
For example:
• CL1-A
Specifies a HOST speed (0, 1, 2, 4, 8).[ -port_speed <value>
]
The contents that can be specified:
0: AUTO
1: 1G
2: 2G
4: 4G
8: 8G
If this specification is omitted, 0 is used.
Specifies a Loop ID (0x01-0xEF) of the port.[-loop_id < alpa
value> ]
0xEF is used if the specification is omitted.
Specifies a topology of the port.[ -topology <
topology> ]
The contents that can be specified:
fl-port : fabric on and fcal
f-port : fabric on and PtoP
nl-port : fabric off and fcal
n-port : fabric off and PtoP
n-port is used if the specification is omitted.
Specifies whether to use the security switch or not.[ -security _switch <
y/n > ]
n is used if the specification is omitted.
Specifies a port attribute.-port_attribute <port
Attribute>
The attributes that can be specified:
TAR: Fiber Target port (Target port)
MCU: MCU Initiator port (Initiator port)
RCU: RCU Target port (RCU target port)
ELUN: External Initiator port (External port)
166 Configuration setting commands