HP P9000 RAID Manager Installation and Configuration User Guide (T1610-96031, October 2011)

The following ports can only be specified for XP12000 Disk Array/XP10000 Disk Array and
XP24000/XP20000 Disk Array:
OptionOptionOptionBasic-
rnqnpnnnmnlnknjnhngnfnendncnbnanCL5
rnqnpnnnmnlnknjnhngnfnendncnbnanCL6
rnqnpnnnmnlnknjnhngnfnendncnbnanCL7
rnqnpnnnmnlnknjnhngnfnendncnbnanCL8
rnqnpnnnmnlnknjnhngnfnendncnbnanCL9
rnqnpnnnmnlnknjnhngnfnendncnbnanCLA
rnqnpnnnmnlnknjnhngnfnendncnbnanCLB
rnqnpnnnmnlnknjnhngnfnendncnbnanCLC
rnqnpnnnmnlnknjnhngnfnendncnbnanCLD
rnqnpnnnmnlnknjnhngnfnendncnbnanCLE
rnqnpnnnmnlnknjnhngnfnendncnbnanCLF
rnqnpnnnmnlnknjnhngnfnendncnbnanCLG
• Target ID: Defines the SCSI/Fibre target ID number of the physical volume on the specified
port. See “Fibre-to-SCSI address conversion ” (page 51) for further information on Fibre address
conversion.
• LU#: Defines the SCSI/Fibre logical unit number (LU#) of the physical volume on the specified
target ID and port.
For Fibre Channel, if the TID and LU# displayed on the system are different from the TID on the
Fibre address conversion table, then use the TID and LU# indicated by the raidscan command in
the RAID Manager configuration file.
• MU# for HOMRCF: Defines the mirror unit number (0 - 2) for the identical LU on the HOMRCF.
If this number is omitted it is assumed to be zero (0). The cascaded mirroring of the S-VOL is
expressed as virtual volumes using the mirror descriptors (MU#1-2) in the configuration
definition file. The MU#0 of a mirror descriptor is used for connection of the S-VOL. Snapshot
will have 64 mirror descriptions in HOMRCF and Snapshot feature.
S-VOLP-VOLSMPLFeature
MU#1 – 63MU#0MU#3 – 63MU#0-2MU#3 – 63MU#0-2
InvalidvalidInvalidvalidInvalidvalidHOMRCF
InvalidvalidvalidvalidvalidvalidSnapshot
Sample configuration definition files 61