HP StorageWorks Virtual Array va 7000 family - Installation Guide
Table Of Contents
- Virtual Array Installation Guide
- Other Information You Will Need
- Operating Environment
- Virtual Array Configurations
- Virtual Array Enclosures
- Hardware Installation
- Configuring the Array Operating Settings
- Step 7. Change the controller default host port behavior
- Step 8. Change the controller port data rate to 2 Gbit/sec
- Step 9. Change the controller port topology
- Step 10. Change the controller loop ID
- Step 11. Change the RAID operating level of the array
- Step 12. Format the array controller enclosure
- Step 13. Power-off the array controller enclosure
- Step 14. Disconnect the RS-232 terminal
- Step 15. Connect fiber optic cables
- Step 16. Power-on all array enclosures
- Installing CommandView SDM Software
- Installing Command View SDM on HP-UX
- Installing Command View SDM on Windows
- Installing Command View SDM on Linux Red Hat
- Final Array Configuration
- Solving Installation Problems
6Contents
Minimum System Requirements for Windows 40
arrays Installation Steps 40
Installing Command View SDM on Linux Red Hat 42
Minimum System Requirements for Linux Red Hat 42
Installation Steps 43
Final Array Configuration 44
Step 18. Gather Host WWNs 44
Step 19. Build the Host Port Behavior Table 45
Step 20. Create LUNs 46
Step 21. Build the Secure Manager LUN Security Table 47
Step 22. Connect All Hosts to the Array 47
Installation of the virtual array is now complete! 47
Solving Installation Problems 48
Hardware Problems 48
Software Problems 49