HP StorageWorks Virtual Array va 7000 family - Installation Guide
Table Of Contents
- Virtual Array Installation Guide
- Other Information You Will Need
- Operating Environment
- Virtual Array Configurations
- Virtual Array Enclosures
- Hardware Installation
- Configuring the Array Operating Settings
- Step 7. Change the controller default host port behavior
- Step 8. Change the controller port data rate to 2 Gbit/sec
- Step 9. Change the controller port topology
- Step 10. Change the controller loop ID
- Step 11. Change the RAID operating level of the array
- Step 12. Format the array controller enclosure
- Step 13. Power-off the array controller enclosure
- Step 14. Disconnect the RS-232 terminal
- Step 15. Connect fiber optic cables
- Step 16. Power-on all array enclosures
- Installing CommandView SDM Software
- Installing Command View SDM on HP-UX
- Installing Command View SDM on Windows
- Installing Command View SDM on Linux Red Hat
- Final Array Configuration
- Solving Installation Problems
4
July 2002
January 2003
Change Page
Added note on connecting only CVSDM hosts to the array until LUN
security is enabled.
27
Added VA 7410 back-end Fibre Channel cabling 29
Removed Compaq Tru64 and Compaq OpenVMS from supported
non-native operating systems.
35
Added note on using the CVSDM GUI to create the host port behavior
table. Also added maximum number of table entries.
45
Add Step 22 to connect all hosts to the array after LUNs have been
created and LUN security implemented.
47
Change Page
Added VA 7110. Multiple