HP StorageWorks Virtual Array va 7000 family - Installation Guide
Table Of Contents
- Virtual Array Installation Guide
- Other Information You Will Need
- Operating Environment
- Virtual Array Configurations
- Virtual Array Enclosures
- Hardware Installation
- Configuring the Array Operating Settings
- Step 7. Change the controller default host port behavior
- Step 8. Change the controller port data rate to 2 Gbit/sec
- Step 9. Change the controller port topology
- Step 10. Change the controller loop ID
- Step 11. Change the RAID operating level of the array
- Step 12. Format the array controller enclosure
- Step 13. Power-off the array controller enclosure
- Step 14. Disconnect the RS-232 terminal
- Step 15. Connect fiber optic cables
- Step 16. Power-on all array enclosures
- Installing CommandView SDM Software
- Installing Command View SDM on HP-UX
- Installing Command View SDM on Windows
- Installing Command View SDM on Linux Red Hat
- Final Array Configuration
- Solving Installation Problems
Virtual Array Installation Guide 37
Installing Command View SDM on HP-UX
Minimum System Requirements for HP-UX
Locating HP-UX Patches
Support Plus Hardware/Critical Patch Bundle information can be found on the
HP-UX Support Plus
CD-ROM, or on the following web page:
http://www.software.hp.com/SUPPORT_PLUS/hwe.html
The latest Java patches for HP-UX can be downloaded from the following web
site:
http://www.hp.com/products1/unix/java/infolibrary/patches.html
Installation Tips
— For the latest information on installing and upgrading the software,
refer to the README file on the
CommandView SDM
Installation CD.
The README is located in the corresponding operating system
directory.
— Make sure EMS hardware monitoring is installed and operating on the
host before installing CommandView SDM. This will ensure that the
Host
■ HP-UX 11.0/11.11 (plus the Support Plus Hardware
Enablement Bundle, version September 2001 or later)
■ RAM: 256 Mbyte
■ Screen Resolution: 800 x 600 (for the GUI)
(Recommended 1024 X 768)
■ Video Support: 64K colors or better
■ Disk Space for Logs: 16 Mbyte per 2 months
■ Disk Space: 60 Mbyte in the /var directory