HP StorageWorks Virtual Array va 7000 family - Installation Guide
Table Of Contents
- Virtual Array Installation Guide
- Other Information You Will Need
- Operating Environment
- Virtual Array Configurations
- Virtual Array Enclosures
- Hardware Installation
- Configuring the Array Operating Settings
- Step 7. Change the controller default host port behavior
- Step 8. Change the controller port data rate to 2 Gbit/sec
- Step 9. Change the controller port topology
- Step 10. Change the controller loop ID
- Step 11. Change the RAID operating level of the array
- Step 12. Format the array controller enclosure
- Step 13. Power-off the array controller enclosure
- Step 14. Disconnect the RS-232 terminal
- Step 15. Connect fiber optic cables
- Step 16. Power-on all array enclosures
- Installing CommandView SDM Software
- Installing Command View SDM on HP-UX
- Installing Command View SDM on Windows
- Installing Command View SDM on Linux Red Hat
- Final Array Configuration
- Solving Installation Problems
36 Virtual Array Installation Guide
Installation Tips
■ For the latest updates on CommandView SDM installation procedures, refer
to the README file provided on the
HP CommandView SDM
CD-ROM.
■ Before installing CommandView SDM, make sure the latest operating
system patches and the latest host adapter drivers and patches are installed
on the host.
■ Have a copy of the
HP StorageWorks
CommandView SDM Installation and
User Guide
available for reference. It contains more detail on the
installation procedures, and additional information on configuring
CommandView SDM for client access.
■ Make sure you have consulted the
Quick Connect Guide(s)
and
Connectivity Streams Documents
- to ensure that all hardware and software
components in the host and the FC infrastructure are supported. These
guides are available on the following internal HP web site:
http://hpso.rose.hp.com/spock/#NASL