Storage Mirroring User Guide

13 - 18
Resources 8200 Warning Failed to allocate buffer for querying very
long filenames, i.e., names over 260
characters. Replication will continue for
standard length filenames. The last Word
in the Data Window is the NT status
code.
Reboot the server and contact technical
support if this event occurs again.
8201 Warning Reached stop replicating page limit.
Replication is stopped.
Configure the applications on the server
to use less memory or add more memory
so that the server does not get into a low
memory state.
8201 Warning Reached stop replicating page limit.
Replication is stopped.
Configure the applications on the server
to use less memory or add more memory
so that the server does not get into a low
memory state.
8202 Error Failed to create Tracked File System
worker thread. The last Word in the
Data Window is the NT status code.
The Storage Mirroring driver cannot
create the thread used by the tracked file
system. If a thread cannot be created, the
system is low on critical resources.
Reboot the server and contact technical
support if this event occurs again.
Service 4000 Info Kernel was successfully started. No action required.
4001 Info Target service was successfully started. No action required.
4002 Info Source service was successfully started. No action required.
4003 Info Source service was successfully stopped. No action required.
4004 Info Target service was successfully stopped. No action required.
4005 Info Kernel was successfully stopped. No action required.
4006 Error Service has aborted due to the following
unrecoverable error: %1
Restart the Storage Mirroring service.
4007 Warning Auto-disconnecting connection ID: %1 Auto-disconnect occurs when the queue
has been filled or if there is a problem
using the queue. Contact technical
support if this event occurs frequently.
4008 Success Auto-disconnect has succeeded on
connection ID: %1
No action required.
4009 Info Auto-reconnecting Replication Set %1 to
%2
No action required.
4010 Success Auto-reconnect has succeeded
connecting Replication Set %1 to %2
No action required.
4011 Error Auto-reconnect has failed connecting
Replication %1 to %2
Manually reestablish the replication set to
target connection.
4014 Info Service has started network transmission. No action required.
4015 Info Service has stopped network
transmission.
No action required.
4016 Info Service has established a connection to
%1 for Replication Set %2, ID: %3
No action required.
4017 Info Service has disconnected from %1 for
Replication Set %2, ID: %3
No action required.
4018 Warning %1, however, mirroring and replication
have been disabled as a restore is
required due to a previous failover.
Perform a restoration.
Category ID Severity Message Required Response