HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)
Compressing data for transmission
1. To determine the current compression setting, use the compression list command.
By default, compression is disabled.
Command
COMPRESSIONLIST
Description
Identifies the compression level and if compression is enabled
Syntax
COMPRESSion LIST
2. To set the level of compression, use the compression set command.
Command
COMPRESSIONSET
Description
Sets the compression level
Syntax
COMPRESSion SET <con_id> <level>
Options
l con_id—Connection ID assigned to the source/target connection
l level—Any whole number from 1 to 3 where 1 is minimum
compression and 3 is maximum compression
Examples
compression set 1 2
Notes
This command only sets the level of compression. It does not initiate
compression.