HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)
Script Add
Command
SCRIPT ADD
Description
Specifies the scripts that should be run at a particular point-in-time during
a process
Syntax
SCRIPT ADD <con_id> [source] <ON target> <type>=<path>
[ARGS=arguments] [DELAY|NODELAY] [INTERACT|NOINTERACT]
Options
l con_id—Connection ID assigned to the source/target connection
l source—Name of the source
l target—Name of the target, an IP address on the target, or a virtual IP
address
l type—Any of the following script types
l MIRRORSTART—This script starts when the target receives the first
mirror operation. In the case of a difference mirror, this may be a long
time after the mirror is started because the script does not start until the
first different data is received on the target. If the data is synchronized
and a difference mirror finds nothing to mirror, the script will not be
executed. The mirror start script will not run for the initial baseline mirror
when a connection is first established.
l MIRRORSTOP—This script starts when a mirror is stopped, which may
be caused by an auto-disconnect occuring while a mirror is running, the
service is shutdown while a mirror is running, or if you stop a mirror
manually.
l MIRRORCOMPLETE—This script starts when a mirror is completed.
Because the mirror statistics may indicate a mirror is at 100% when it is
actually still processing (for example, if files were added after the
replication set size was calculated, if there are alternate data streams,
and so on), the script will not start until all of the mirror data has been
completely processed on the target.
l path—Specify the full path and file name (including the file extension)
to the script on the target. Do not include arguments with the path, only