HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)

Monitor Move
Command
MONITOR MOVE
Description
Designates the IP address that will be failed over to the specified target
NIC
Syntax
MONitor MOVE <IP_address> TO NIC <target_NIC> USE NONE |
NETWORK INTERVAL <interval> TIMEOUT <timeout> | SERVICE
INTERVAL <interval> TIMEOUT <timeout> | <NOTEST> [monitor]
Options
l IP_address—The IP address which should be moved during failover
l target_NIC—The integer value of the target NIC obtained from the
niclist command
l NONE—Does not actively monitor the source machine. You will be
responsible for identifying when a failure has occurred and initiating
failover manually.
l NETWORK—Monitors the source by looking for a Storage Mirroring
Recover network response
l SERVICE—Monitors the source by looking for Storage Mirroring
service response
l INTERVAL interval—The frequency, in seconds, of the monitor
requests sent to the source machine to see if it is online and active
l TIMEOUT timeout—The number of seconds before failover will occur.
This number is reset to its maximum each time the source sends a
response to the monitor request.
l NOTEST—Allows you to failover an IP address without sending
monitor requests or expecting responses from the source. This option
should only be used if you are monitoring multiple IP addresses but do
not want to send monitor requests to each address.
l monitor—Name of the source machine designated as the monitor
Examples
l monitor move 205.31.2.57 to nic 1 use network interval 5 timeout 25
l monitor move 205.31.2.68 to nic 2 use none notest