HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)

Limit Bandwidth
Command
LIMIT BANDWIDTH
Description
Sets a fixed bandwidth limitation for transmitting data from the source to
the target
Syntax
LIMIT BANDWIDTH <bytes>, <seconds> TO <target>
Options
l bytes—Number of bytes to be transmitted
l seconds—Maximum number of seconds to wait before transmitting
again
l target—Name of the target, an IP address on the target, or a virtual IP
address. Depending on the network route Storage Mirroring Recover
uses to access the target, you may need to specify the fully qualified
domain name.
Examples
limit bandwidth 19300, 5 to beta
Notes
l This command transmits in bursts, not bytes per seconds. The time
identifies how long to wait before transmitting again. For example, if 5
seconds are specified and it only takes 2 seconds to send the specified
bytes, Storage Mirroring Recover will wait an additional 3 seconds
before transmitting again.
l Target names that contain non-alphanumeric characters must be
enclosed in quotation marks.