HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)

FileAccessRetry
Description—The number of times a failed driver call will be retried by the
service.
Values—1 - 65535
Default—10
GUI Setting—None
Service restart required—No
FileQueueSize
Description—When a mirror is started, one thread reads from the disk
and builds the file queue. Another set of threads reads files off of the
queue and sends them to the target. This setting is the maximum size of
the queue in entries. If you had 100 files to be mirrored and this was set to
16 (the default value), the first thread would fill the queue to a maximum of
16 entries.
Values—1 - 65535
Default—16
GUI Setting—None
Service restart required—No
Notes—This value must be set prior to starting the mirror process. The
higher the number, the more memory that is used.
ForceReplaceOnFailover
Description—Specifies additional failover options
Values—0 Use standard failover add / replace settings with no additional
settings, 1 Replace the target server name with that of the source and add
the source IP address, 2 Add the source server name to the target and
replace the target IP address, 3 Replace the target server name with that
of the source and replace the target IP address
Default—0
GUI Setting—Failover Control Center, Monitor Settings, Failover Method
Service restart required—No
ForceVerifyOnMirror
Description—Specifies if verification will be performed with every
difference mirror