HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)

97 of 332
SERVICE INTERVAL <interval> TIMEOUT <timeout> |
<NOTEST> [monitor]
Options
● IP_address—The IP address which should be moved during
failover
● target_NIC—The integer value of the target NIC obtained
from the niclist command
● NONE—Does not actively monitor the source machine. You
will be responsible for identifying when a failure has occurred
and initiating failover manually.
● NETWORK—Monitors the source by looking for a Storage
Mirroring Recover network response
● SERVICE—Monitors the source by looking for Storage
Mirroring service response
● INTERVAL interval—The frequency, in seconds, of the
monitor requests sent to the source machine to see if it is
online and active
● TIMEOUT timeout—The number of seconds before failover
will occur. This number is reset to its maximum each time the
source sends a response to the monitor request.
● NOTEST—Allows you to failover an IP address without
sending monitor requests or expecting responses from the
source. This option should only be used if you are monitoring
multiple IP addresses but do not want to send monitor
requests to each address.
● monitor—Name of the source machine designated as the
monitor
Examples
● monitor move 205.31.2.57 to nic 1 use network interval 5
timeout 25
● monitor move 205.31.2.68 to nic 2 use none notest
● mon move 205.31.2.68 to nic 2 use none notest
Notes
● If you do not specify a monitor, the current source designated
as the monitor will be used. If you have not identified a
monitor, you will receive an error message stating that a
monitor has not been selected.
● If you choose to use the service option, your source and target
must be using the same Storage Mirroring Recover port
settings. If you choose to use the network option, the port