HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)
80 of 332
Options
● con_id—Connection ID assigned to the source/target
connection
● target—Name of the target, an IP address on the target, or a
virtual IP address
Examples
● snapshot schedule 1 display
● snap sched 1 disp
Notes
Target names that contain non-alphnumeric characters must be
enclosed in quotation marks.
3. You can disable a snapshot schedule, without losing the schedule configuration,
by using the snapshot schedule disable command.
Command SNAPSHOT SCHEDULE DISABLE
Description Disables a snapshot schedule
Syntax SNAPshot SCHEDule <con_id> DISABLE [ON <target>]
Options
● con_id—Connection ID assigned to the source/target
connection
● target—Name of the target, an IP address on the target, or a
virtual IP address
Examples
● snapshot schedule 1 disable
● snap sched 1 disable
Notes
● This command only disables the snapshot schedule for this
connection so that it will not run. It does not clear the snapshot
schedule parameters.
● Target names that contain non-alphnumeric characters must
be enclosed in quotation marks.
4. You can enable a disabled snapshot schedule by using the snapshot schedule
enable command.
Command SNAPSHOT SCHEDULE ENABLE
Description Enables a disabled snapshot schedule
Syntax SNAPshot SCHEDule <con_id> ENABLE [ON <target>]
Options
● con_id—Connection ID assigned to the source/target
connection