HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)

302 of 332
Snapshot Delete
Command SNAPSHOT DELETE
Description Deletes the specified snapshot(s) from the target
Syntax
SNAPshot DELete <con_id> <snapshot_list_number | ALL | OLD
[ GOOD | BAD ] > [ON <target>]
Options
● con_id—Connection ID assigned to the source/target
connection
● snapshot_list_number—The snapshot number retrieved
from the SNAPSHOT LIST command
● ALL—Deletes all snapshots
● OLD—Deletes only the oldest snapshot
● GOOD—If specified, deletes only good snapshot. If used with
ALL, all good snapshots will be deleted. If used with
OLDEST, only the oldest good snapshot will be deleted.
● BAD—If specified, deletes only bad snapshots. If used with
ALL, all bad snapshots will be deleted. If used with OLDEST,
only the oldest bad snapshot will be deleted.
● target—Name of the target, an IP address on the target, or a
virtual IP address
Examples
● snapshot delete 1 3
● snapshot delete 1 all bad
● snap del 1 oldest
Notes
● Snapshots are labeled as good or bad depending on the state
of the target at the time the snapshot was taken.
● Target names that contain non-alphanumeric characters must
be enclosed in quotation marks.