HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)

292 of 332
Script Add
Command SCRIPT ADD
Description
Specifies the scripts that should be run at a particular point-in-time
during a process
Syntax
SCRIPT ADD <con_id> [source] <ON target> <type>=<path>
[ARGS=arguments] [DELAY|NODELAY]
[INTERACT|NOINTERACT]
Options
● con_id—Connection ID assigned to the source/target
connection
● source—Name of the source
● target—Name of the target, an IP address on the target, or a
virtual IP address
● type—Any of the following script types
● MIRRORSTART—This script starts when the target
receives the first mirror operation. In the case of a
difference mirror, this may be a long time after the mirror
is started because the script does not start until the first
different data is received on the target. If the data is
synchronized and a difference mirror finds nothing to
mirror, the script will not be executed. The mirror start
script will not run for the initial baseline mirror when a
connection is first established.
● MIRRORSTOP—This script starts when a mirror is
stopped, which may be caused by an auto-disconnect
occuring while a mirror is running, the service is
shutdown while a mirror is running, or if you stop a
mirror manually.
● MIRRORCOMPLETE—This script starts when a mirror
is completed. Because the mirror statistics may indicate
a mirror is at 100% when it is actually still processing
(for example, if files were added after the replication set
size was calculated, if there are alternate data streams,
and so on), the script will not start until all of the mirror
data has been completely processed on the target.
● path—Specify the full path and file name (including the file
extension) to the script on the target. Do not include
arguments with the path, only the path and file name. Enclose