HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)

219 of 332
Limit Bandwidth
Command LIMIT BANDWIDTH
Description
Sets a fixed bandwidth limitation for transmitting data from the
source to the target
Syntax LIMIT BANDWIDTH <bytes>, <seconds> TO <target>
Options
● bytes—Number of bytes to be transmitted
● seconds—Maximum number of seconds to wait before
transmitting again
● target—Name of the target, an IP address on the target, or a
virtual IP address. Depending on the network route Storage
Mirroring Recover uses to access the target, you may need to
specify the fully qualified domain name.
Examples limit bandwidth 19300, 5 to beta
Notes
● This command transmits in bursts, not bytes per seconds.
The time identifies how long to wait before transmitting again.
For example, if 5 seconds are specified and it only takes 2
seconds to send the specified bytes, Storage Mirroring
Recover will wait an additional 3 seconds before transmitting
again.
● Target names that contain non-alphanumeric characters must
be enclosed in quotation marks.