HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96009, November 2009)

105 of 332
Editing failover monitoring configuration
1. Specify your active monitor by using the monitor get command.
Command MONITOR GET
Description Identifies a machine as the active monitor machine
Syntax MONitor GET <target>
Options
target—Name of the target, an IP address on the target, or a virtual
IP address
Examples
● monitor get beta
● mon get beta
Notes
Monitor names that contain non-alphanumeric characters must be
enclosed in quotation marks.
2. Review the current failover settings by using the monitor display command.
Command MONITOR DISPLAY
Description
Displays the monitoring and failover configuration settings for the
specified monitor machine
Syntax MONitor DISPlay <monitor>
Options monitor—Name of the source machine designated as the monitor
Examples
● monitor display alpha
● mon disp alpha
Notes
● If you do not specify a monitor, the current source designated
as the monitor will be used. If you have not identified a
monitor, you will receive an error message stating that a
monitor has not been selected.
● Depending on your sequence of commands, you may need to
use the monitor get command to specify an active monitor
before using monitor display.
● Monitor names that contain non-alphanumeric characters
must be enclosed in quotation marks.
3. If you need to edit any of the failover settings, use the failover configuration
commands used to establish the failover configuration.