HP OpenView Storage Mirroring Getting Started (359447-001, May 2004)
12
Example DTSetup.ini for Client Only Installation
Use the appropriate instructions depending on if you are performing a local
or remote Storage Mirroring installation automatically. The local
installation is below and the remote installation is on the following page.
! Local, automatic Storage Mirroring installation
1. Create a temporary directory on the machine. For example,
create c:\dtinstall.
2. Copy the files from the DblTake\NT2000 directory on the
Storage Mirroring CD-ROM to the temporary directory.
3. From a command prompt, remove the read-only attributes from
the files in the temporary directory by using the command
attrib *.* -r.
4. Make a backup copy of the default DTSetup.ini file in the
temporary directory.
5. Edit DTSetup.ini as needed using the values described in the
previous tables.
6. Run the following case-sensitive command from the temporary
directory:
setup /s
/v"DTSETUPINI=\"c:\dtinstall\DTSetup.ini\" /qn"
7. After the installation is complete, reboot the machine.
[Double-Take]
DTSETUPTYPE=DTNT
DTACTIVATIONCODE=01a2b000304c056d
AUTOREBOOT=Y
[Client]
DOUBLETAKEFOLDER="
C:\Program Files\OpenViewStorage
Mirroring
"
MANAGEMENTCONSOLE=Y
TEXTTOOLS=Y
CLUSTERCLIENT=Y
SNMP=N
NOTE: The command must be run from the directory where
the temporary files are located as well as specifying
that directory for the .ini file.
Spacing is critical with this command. A space should
precede /s, /v, and /qn but should not appear
anywhere else for the command to work correctly.
NOTE: If you have configured the AutoReboot option to yes,
the machine will automatically reboot.