HP StorageWorks SSL1016 Chassis Replacement Instructions (April 2003)

56
Make sure the power switch on the back of the
DCA is off (the 0 is pressed), then connect the
power cord and SCSI cable. On the power
switch on the back of the DCA, press the | to
power on the autoloader.
7
Grasp the DCA by the handle with one hand
and support it underneath with the other hand.
Slide the DCA into the bay of the replacement
chassis. Make sure you position the DCA
correctly; it should slide smoothly.
Install four screws that secure the DCA to the
chassis. Tighten firmly.
replacement
Getting Help
• HP Product Information Site:
http://www.hp.com/products/tapestorage
• HP Technical Support and Phone Numbers:
http://www.hp.com/support
• HP StorageWorks Library and Tape Tools
(L&TT) diagnostic software:
http://www.hp.com/support/tapetools
© 2003 Hewlett-Packard Company
First Edition (April 2003)
Part Number: 335901-001
*335901-001*
335901-001