HP StorageWorks SSL1016 Chassis Replacement Instructions (April 2003)
hp
StorageWorks
SSL1016
chassis
replacement
Caution: Parts can be damaged by
electrostatic discharge. Use proper ESD
protection.
Caution: Avoid touching the
exposed board on the bottom
of the DCA.
Power off the autoloader. Disconnect all cords
and cables from the back of the DCA. Remove
the four screws anchoring the DCA to the chassis.
2
3
Before beginning, be sure the tape drive does not
contain a cartridge. To remove a cartridge, see
the hp StorageWorks SSL1016 tape autoloader
reference guide. You must also turn off power to
the autoloader and disconnect the power and
SCSI cables from the back of the DCA.
1
Configuration and Tools
If you replace the chassis, you need to check
the configuration settings for the DCA and the
SCSI bus.
You will need a Phillips screwdriver to remove
and replace the DCA.
removal
With one hand, grasp the DCA handle and slide
it backward to remove. Being careful not to touch
the exposed board on the bottom of the DCA,
place your other hand under the DCA to support
it and prevent it from falling.
4