HP StorageWorks Scalable File Share System Installation and Upgrade Guide Version 2.2

Configuring a factory-installed system4–4

servers are assigned an IP address by incrementing this IP address.

Enter the Start IP (e.g. 1.2.3.4 or None) [10.128.0.11]: 16.123.123.1

Enter the Netmask [255.255.255.0]:

Enter the MTU [1500]:

Enter the static routes in the form:

<network>,<netmask>,<gateway>; ...

For example to add the following two static routes:

network 10.10.0.0, netmask 255.255.0.0, gateway 10.128.8.1

network 10.0.0.0, netmask 255.255.0.0, gateway 10.64.0.1

Enter the following:

10.10.0.0,255.255.0.0,10.128.8.1;10.0.0.0,255.255.0.0,10.64.0.1

Enter the Static Routes [None]:

Enter the Alias IP (e.g. 1.2.3.4 or None) [10.128.0.20]: 16.123.123.200

Do you want to Configure the network device on all servers [yes]: yes

The Network Device (eth1) configuration is

Type of network tcp

Start IP 16.123.123.1

Netmask 255.255.255.0

MTU 1500

Static Routes None

Alias IP 16.123.123.200

Configure the network device on all servers yes

Is this correct? [yes]: yes

Configure Gigabit Ethernet Networks --------------------------------------------

This section is used to configure the Gigabit Ethernet networks, excluding

the Management Network. If configured on all servers, these networks can be

used as an interconnect to client systems. If not configured on all servers,

these networks are only configured on the Administration and MDS servers and

are used to connect to your site network. If you do not want to configure the

Gigabit Ethernet networks you can proceed to the next section.

Use the Add a Bonded Network device option if you want to add a bonded device.

Use the Delete a Bonded Network device option if you want to delete a bonded

device.

Note: a network device is marked as Unused if a Start IP for the

network has not been entered. Once a Start IP is entered the device

is marked as Inuse.

1) eth1 Inuse

2) Add a Bonded Network device

3) Delete a Bonded Network device

a) All of the above

n) Next Section

p) Previous Section

c) Cancel

Enter your choice [a]: