HP StorageWorks Scalable File Share System Installation and Upgrade Guide Version 2.2

Step 3: Connecting the system to the site network 4–3
Enter your choice [a]: 1
Configure Gigabit Ethernet Networks --------------------------------------------
This section is used to configure the Gigabit Ethernet networks, excluding
the Management Network. If configured on all servers, these networks can be
used as an interconnect to client systems. If not configured on all servers,
these networks are only configured on the Administration and MDS servers and
are used to connect to your site network. If you do not want to configure the
Gigabit Ethernet networks you can proceed to the next section.
Use the Add a Bonded Network device option if you want to add a bonded device.
Use the Delete a Bonded Network device option if you want to delete a bonded
device.
Note: a network device is marked as Unused if a Start IP for the
network has not been entered. Once a Start IP is entered the device
is marked as Inuse.
1) eth1 Inuse
2) Add a Bonded Network device
3) Delete a Bonded Network device
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [a]:
5. Choose the ethernet device used to connect the system to the site network (in this example it is eth1),
and then enter a to select All of the above, as shown in the following example. Replace the
existing values with the network information that you identified in your preinstallation planning in
Section 2.5 and recorded in the worksheet in Table B-5, as shown in the following example. In this
example, the IP addresses are 16.123.123.200, 16.123.123.1 and 16.123.123.2:
Enter your choice [a]: 1
Network Device (eth1) ----------------------------------------------------------
This section is used to configure a Network Device.
The Start IP is the IP assigned to the Administration server. The addresses
of the remaining servers are determined by incrementing the address of the
Administation server.
An alias IP can be configured on the network. The alias IP is configured
on the Administration server and will failover to the MDS server when the
Administration server is shutdown.
If you choose no to the question to configure the device on all servers,
the network device is only configured on the Administration and MDS servers.
Otherwise the network device is configured on all servers.
1) Type of network tcp
2) Start IP 10.128.0.11
3) Netmask 255.255.255.0
4) MTU 1500
5) Static Routes None
6) Alias IP 10.128.0.20
7) Configure the network device on all servers yes
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [a]: a
Enter the Type of network [tcp]:
Once you specify the IP address of the Admin server the remaining