HP StorageWorks Scalable File Share System Installation and Upgrade Guide Version 2.2

Installing the servers — SFS20 storage7–14
Enter the Type of network [tcp]:
Enter the slave devices as a comma separted list of eth devices.
The available ethernet devices are:
eth1,eth2,eth3
Enter the Slave devices (e.g. eth2,eth3) [None]: eth2,eth3
Once you specify the IP address of the Admin server the remaining
servers are assigned an IP address by incrementing this IP address.
Enter the Start IP (e.g. 1.2.3.4 or None) [None]: 10.128.0.71
Enter the Netmask [255.255.255.0]:
Enter the MTU [1500]:
Enter the Alias IP (e.g. 1.2.3.4 or None) [None]: 10.128.0.80
Do you want to Configure the network device on all servers [yes]:
The Add a Bonded Network device (bondN) configuration is
Type of network tcp
Slave devices eth2,eth3
Start IP 10.128.0.71
Netmask 255.255.255.0
MTU 1500
Alias IP 10.128.0.80
Configure the network device on all servers yes
Is this correct? [yes]:
Configure Gigabit Ethernet Networks --------------------------------------------
This section is used to configure the Gigabit Ethernet networks, excluding
the Management Network. If configured on all servers, these networks can be
used as an interconnect to client systems. If not configured on all servers,
these networks are only configured on the Administration and MDS servers and
are used to connect to your site network. If you do not want to configure the
Gigabit Ethernet networks you can proceed to the next section.
Use the Add a Bonded Network device option if you want to add a bonded device.
Use the Delete a Bonded Network device option if you want to delete a bonded device.
Note: a network device is marked as Unused if a Start IP for the
network has not been entered. Once a Start IP is entered the device
is marked as Inuse.
1) eth1 Unused
2) eth2 Inuse
3) eth3 Inuse
4) bond0 Inuse
5) Add a Bonded Network device
6) Delete a Bonded Network device
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [a]:
To proceed to the next menu, enter n.
NOTE: Certain attributes of bonded Gigabit Ethernet interconnects are stored in the bonding_options
attribute. If there is more than one bonded network, the attributes are common to all bonded networks.You
can change these attributes after the system is installed. Refer to Chapter 7 of the HP StorageWorks
Scalable File Share System User Guide for more information.