HP StorageWorks Scalable File Share System Installation and Upgrade Guide Version 2.2

Step 4: Configuring the system parameters 7–11
Example 7-4 Network Device menu
Network Device (eth1) ----------------------------------------------------------
This section is used to configure a Network Device.
The Start IP is the IP assigned to the Administration server. The addresses
of the remaining servers are determined by incrementing the address of the
Administation server.
An alias IP can be configured on the network. The alias IP is configured
on the Administration server and will failover to the MDS server when the
Administration server is shutdown.
If you choose no to the question to configure the device on all servers,
the network device is only configured on the Administration and MDS servers.
Otherwise the network device is configured on all servers.
1) Type of network tcp
2) Start IP None
3) Netmask 255.255.255.0
4) MTU 1500
5) Static Routes None
6) Alias IP None
7) Configure the network device on all servers yes
a) All of the above
n) Next Section
p) Previous Section
c) Cancel
Enter your choice [a]:
Valid network types are: tcp
The tcp value is valid for the following networks:
o Gigabit Ethernet
o Dual Gigabit Ethernet
o Bonded network
Note that component devices of a bonded network are automatically
assigned a network type of slave. This value should not be changed.
Enter the Type of network [tcp]:
Once you specify the IP address of the Admin server the remaining
servers are assigned an IP address by incrementing this IP address.
Enter the Start IP (e.g. 1.2.3.4 or None) [None]: 16.123.123.101
Enter the Netmask [255.255.255.0]:
Enter the MTU [1500]:
Enter the static routes in the form:
<network>,<netmask>,<gateway>; ...
For example to add the following two static routes:
network 10.10.0.0, netmask 255.255.0.0, gateway 10.128.8.1
network 10.0.0.0, netmask 255.255.0.0, gateway 10.64.0.1
Enter the following:
10.10.0.0,255.255.0.0,10.128.8.1;10.0.0.0,255.255.0.0,10.64.0.1
Enter the Static Routes [None]:
Enter the Alias IP (e.g. 1.2.3.4 or None) [None]: 16.123.123.120
Do you want to Configure the network device on all servers [yes]:
The Network Device (eth1) configuration is