HP StorageWorks Scalable File Share for SFS20 Enclosure Hardware Installation Guide Version 2.2

Figure 7-13 ProCurve Switch 2650 LEDs
2
3
5
4
7
6
Table 7-12 ProCurve LED Identification
MeaningStateDescriptionItem
On = The switch is receiving power.
Off = The switch is not receiving power.
GreenPower1
On = The switch has encountered a fatal hardware failure or has failed its
self-test.
Off = Indicates that there are no fault conditions on the switch.
Blinking* = A fault has occurred on the switch, one of the switch ports, or
the fan. The status LED for the component with the fault will blink
simultaneously.
OrangeFault2
On = The switch self-test and initialization are in progress after you have
power cycled or reset the switch. The switch is not operational until this
LED goes off.
Off = The switch is not undergoing self test.
Blinking* = A component of the switch has failed its self-test. The status
LED for that component and the switch Fault LED will blink
simultaneously.
GreenSelf-Test3
Displays port link information, network activity information, whether the
port is configured for full-duplex operation, or the speed of the connection,
depending on the Port LED View selected.
Green —
overlaid
with the
port number
Port LEDs4
Link = Indicates that the port LEDs are displaying link information. If the
port LED is on, the port is enabled and receiving a link indication from
the connected device. If the port LED is off, the port has no active network
cable connected, or is not receiving link beat or sufficient light. Otherwise,
the port may have been disabled through the switch console, the Web
browser interface, or HP TopTools. If the port LED is blinking*
simultaneously with the Fault LED, the corresponding port has failed its
self-test.
Act = Indicates that the port LEDs are displaying network activity
information.
FDx = Indicates that the port LEDs are lit for ports that are in full-duplex
mode.
Spd = Indicates that the port LEDs are displaying the connection speed at
which each port is operating. If the port LED is off, the port is operating
at 10 Mb/s. If the port LED is flashing**, the port is operating at 100 Mb/s,
and if the port LED is on continuously, the port is operating at 1000 Mb/s.
4 green
LEDs
Port LED View5
On = The cooling fan is working properly.
Off = The cooling fan has failed. The switch Fault LED will be blinking
simultaneously.
GreenFan Status6
92 Hardware Component LEDs