HP StorageWorks Reference Information Storage System V1.0 Administrator Guide (May 2004)

PCC Views, Detailed Descriptions Chapter 2: Persist Control Center
HP StorageWorks Reference Information Storage System Administrator Guide, April 2004 2-89
Table 2-88: User Manager View, Assignment Features
Feature Description
Create 1.Click Create to specify a new assignment. An entry form
is displayed.
2.Enter the following values:
– ConfigID – The DAS configuration that is to be run on
the portal (specified below). Select the configuration
from the pulldown list. (Use the Configurations link to
create a configuration.)
– DAS Server IP – The IP address of the HTTP portal
where the DAS service runs the selected DAS
configuration.
– Configuration Enabled – Whether or not the selected DAS
configuration is available to be run. To finish a new
assignment, select Yes so that you can run the service
and set up necessary database and configuration files
(see steps 4 and 5).
– Configuration running state – (for future use)
– Period (mn) – The number of minutes between runs of
the selected DAS configuration. A period of 0 means
the job will run once.
– DAS server running state – (for future use)
3.Click Update to save your entries.
4.In the Configuration Command Panel, select Yes for Initialize
DAS setup. (Select Yes only when you are scheduling or
starting the DAS configuration for the first time, or if you
need to resynchronize the database in recovery from an
unusual event.)
5.Click Start to run the DAS configuration immediately.
6.Click Back to main to return to the User Manager view, or
click Back to return to Assignment.
7.When DAS has updated the database, return to the
Assignment view and change the configuration as follows:
–In the Configuration Command Panel, select No for Initialize
DAS setup.
–Click Schedule to run the DAS configuration
periodically (as specified in step 2).
Leaving Initialize DAS setup set to Yes after the first run
prevents DAS from properly updating RISS user accounts.