HP StorageWorks Reference Information Storage System V1.1 Administrator Guide (February 2005)

External Command Interface view Chapter 2: Platform Control Center
HP StorageWorks Reference Information Storage System Administrator Guide, February 2005 2-143
External Command Interface view
Use this view to run commands that perform actions. Some commands allow
or require additional command information. Fields labeled in red are required
input. To run a command, enter command information, and click
Commit .
Reset clears all input fields.
Some commands are applicable to individual hosts or services, all hosts of a
host group, or all services running on a host.
Note: Commands that disable (notifications, status checks, and so on)
override commands that enable. For example, suppose you
disable checks for a particular service, such as
PING , using the
Service Information view (command Disable checks of this service ), but
enable checks for all services using the
Nagios Info view (command
Start executing service checks ). That particular service ( PING ) is not
checked because disabling overrides enabling.
Table 2-121: External commands
Shut down (stop) Nagios process (PCC monitoring), so RISS is no longer monitored.
Restart Nagios process (PCC monitoring).
Enable or disable sending notifications for hosts or services. See
Example: Enabling
or disabling notifications
, on page 2-144 .
Enable or disable host or service checks (monitoring).
Add host or service comments. See
Example: Adding comments , on page 2-144 .
Schedule host or service downtimes.
Schedule immediate check of all services on host.
Reschedule next check of service.