HP P6000 Continuous Access Implementation Guide (T3680-96431, August 2012)

Performing failover and recovery
Failover and recovery procedures include such actions as failover, suspend, resume, disable failsafe,
mounting, and unmounting. You can perform these actions using the following interfaces and tools:
• HP P6000 Replication Solutions Manager GUI
• HP P6000 Replication Solutions Manager CLI
• HP P6000 Replication Solutions Manager jobs
• HP Storage System Scripting Utility
• HP P6000 Command View
For specific procedures, see the interface documentation.
Choosing a failover procedure
Table 5 (page 105) summarizes situations that require a failover and those that do not. Each
recommended action corresponds to a procedure documented later in this chapter. Because
replication can be bidirectional, your array may be a source and a destination for separate DR
groups. Use this table to customize contingency plans for your environment.
104 Failover and recovery