HP XP7 Performance Advisor v6.1 Software Troubleshooting and FAQs Guide

Table 12 Configuring the host agent: ManagementStation.Hostname (continued)
C:\Program Files\Hewlett- Packard\xppa\
hostagent\config\xpmgmtstationaddress.prp.
These parameters are read when the host agent is started. The
host normally executes as a service under Microsoft Windows
or as a daemon under UNIX.
When Read
IP address or fully-qualified network name of management station.
NOTE: This host agent is configured automatically during host
agent installation. Configure this host agent manually only when
you want to change the management station after installing the
host agent.
Discussion
The xpmgmtstationaddress.prp file needs to be updated
with the IP address of the management station, if you want to
use a different management station after installing the host agent.
Table 13 Configuring the host agent: ManagementStation.PollIntervalMilliSeconds
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
If installed in a different location, the path is as follows:
<Installation drive>:\xppa\hostagent\
config\paxp_service.properties.
On UNIX platforms:
/opt/xppa/hostagent/config/
paxp_service.properties
This parameter is read and specified at run time.When Read
The frequency at which the Host station polls the
Management station for updates. The default for the polling
cycle is 60000 (60 seconds).
Discussion
Table 14 Configuring the password required to access HP XP7 Performance Advisor
You can change the user and administrator passwords
through the Security screen of HP XP7 Performance Advisor.
NOTE: If you are the administrator, you can change other
user(s) and administrator(s) passwords on the Security
screen of HP XP7 Performance Advisor, only if HP XP7
Performance Advisor is enabled for Native authentication.
You cannot change the passwords for domain and system
authenticated user accounts.
Discussion
Table 15 Disabling recover alarm notification
...%HPSS_HOME%/pa/properties/serverparameters.propertiesFile
You can disable recover alarm notification through the
Alarm Configuration page of HP XP7 Performance Advisor.
NOTE: You can also configure the email (SMTP) courier
settings for reports from the HP XP7 Performance Advisor
GUI. For more information, see the HP XP7 Performance
Advisor Software User Guide.
Discussion
Table 16 Configuring the host agent: Logger.DebugLevel
On Windows platforms:
C:\Program Files\Hewlett-Packard\xppa\
hostagent\config\paxp_service.properties
File
80 Frequently Asked Questions