HP XP7 Performance Advisor Software 6.1 Command-line User Interface Reference Guide
Enables you to select metric values and monitor them for a particular metric. Also, you can configure
threshold and dispatch settings, email and SNMP notifications, and enable alarms on these metric
values.
Switches
Required. Specify the array serial number. Not required if -list is used.–dkc <serial num>
Required Specify the csv list of items for which alarms are being created.
Not required if -list is used.
–mval <Item List>
Required Specify the alarm metric to watch. Not required if -list is used. Valid values are:
nl
–metric <Metric
Category>
IO_TOTAL LDEV IO Total
nl
IO_RAND_TOTAL LDEV IO Random Total
nl
IO_RAND_READ LDEV IO Random Read
nl
IO_RAND_READ_CACHE LDEV IO Random Read Cache Hits
nl
IO_RAND_WRITE LDEV IO Random Write
nl
IO_RAND_WRITE_CACHE LDEV IO Random Write Cache Hits
nl
IO_SEQ_TOTAL LDEV IO Sequential Total
nl
IO_SEQ_READ LDEV IO Sequential Read
nl
IO_SEQ_READ_CACHE LDEV IO Sequential Read Cache Hits
nl
IO_SEQ_WRITE LDEV IO Sequential Write
nl
IO_SEQ_WRITE_CACHE LDEV IO Sequential Write Cache Hits
nl
MB_TOTAL LDEV MB Total
nl
MB_RAND_TOTAL LDEV MB Random Total
nl
MB_RAND_READ LDEV MB Random Read
nl
MB_RAND_WRITE LDEV MB Random Write
nl
MB_SEQ_TOTAL LDEV MB Sequential Total
nl
MB_SEQ_READ LDEV MB Sequential Read
nl
MB_SEQ_WRITE LDEV MB Sequential Write
nl
nl
nl
nl
CACHEMODE_INHIBIT LDEV IO type
nl
CACHEMODE_BYPASS LDEV IO type
nl
PORT_IO_MAX Port Maximum IO/s
nl
PORT_IO_MIN Port Minimum IO/s
nl
PORT_IO_AVE Port Average IO/s
nl
PORT_MB_MAX Port Maximum MB/s
nl
PORT_MB_MIN Port Minimum MB/s
nl
PORT_MB_AVE Port Average MB/s
nl
FBUS_HI DKC Bus Utilization
nl
FBUS_LO DKC Bus Utilization
nl
MBUS_HI DKC Bus Utilization
nl
MBUS_LO DKC Bus Utilization
nl
BACKEND_SEQ_READ LDEV Backend
nl
BACKEND_NONSEQ_READ LDEV Backend
nl
BACKEND_WRITE LDEV Backend
nl
THP_POOL_OCCUPANCY
nl
SNAPSHOT_POOL_OCCUPANCY
Indicates that the command must list only configured alarms.–list
Specify the address of a management station in the format <http://
path.to.managementstation:<port>> or <https://
path.to.managementstation>.
–ms <management
station>
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Can be used in place of -auth.
NOTE: The password file must be created using only the encrypt command.
–pf <password file>
Specify the threshold level.–th <threshold>
Specify a csv list of email destinations.–email <Email List>
Specify a csv list of SNMP destinations.–snmp <SNMP List>
Indicates the alarm is enabled.–e
26 CLUI commands