HP StorageWorks XP Performance Advisor Software v4.6 Command-line User Interface Reference Guide (T1789-96095, June 2010)

17This means S(S)vol Journal is Normal NormalJSTAT_SJNN
18This means S(S)vol Journal is Suspend Normal.JSTAT_SJNF
19This means S(S)vol Journal is Normal Full.JSTAT_SJSN
20This means S(S)vol Journal is Suspend Full.JSTAT_SJSF
21
This means S(S)vol Journal is Suspend Error including Link
failure.
JSTAT_SJSE
Displays the actual number of paths.AP
Displays the usage rate of the journal pool in percentage format.U(%)
Displays the sequence number for the journal group ID, called the Q-marker.Q-Marker
Displays the number of remaining Q-Markers within each journal volume.Q-CNT
Displays the number of volumes configured for the journal group.Num
Displays the ID of the volume configured for the journal group.LDEV#
Displays the average read response time of the volume configured for the journal group.Avg Read
Displays the maximum read response time of the volume configured for the journal group.Max Read
Displays the average write response time of the volume configured for the journal group.Avg Write
Displays the maximum write response time of the volume configured for the journal group.Max Write
Switches
Required: Specify the array serial number.—dkc <serial #>
Specify the journal ID.
–jid <journal pool
id>
The journal LDEV's read and write response time.–resp
Specify the start time in the format mm.dd.yyyy hh:mm:ss.
–st <mm.dd.yyyy
hh:mm:ss>
Specify the end time in the format mm.dd.yyyy hh:mm:ss.
–et <mm.dd.yyyy
hh:mm:ss>
Specify the address of a management station in the format <http://path.to.management-
station/>.
–ms <URL>
Specify a user name and password pair in the format user name:password.
–auth <user:pass-
wd>
Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
–pf <password
file>
Specify the delimiter for delimited display.–d<delim>
CLUI commands46