HP StorageWorks XP Performance Advisor Software v4.6 Command-line User Interface Reference Guide (T1789-96095, June 2010)

NOTE:
If an array is connected to a host agent that is running the HP-UX 11i v3 operating system, the DSF
(device special file) is displayed in a new format. A legacy DSF is displayed in parenthesis next to
the new format.
Cache Fast Writes and DASD Fast Writes are applicable for mainframe volumes only.
For an XP24000 array with XP Thin Provisioning and XP Snapshot, the output displayed, under RAID
Group, for XP Thin Provisioning is THP-PID<pool ID> and the output for Snapshot is
SNAP-PID<pool ID>.
For an XP24000 array with XP Thin Provisioning and XP Snapshot under RAID Group, the following
output is displayed:
• For XP Thin Provisioning:
THP-PID<pool ID>
• For XP Snapshot:
SNAP-PID<pool ID>.
Switches
Required. Specify the array serial number. The word "all" can be used to indicate
all DKCs.
–dkc <serial #>
Specify the delimiter for delimited output. There is no space between -d and the
delimiter.
–d<delim>
Specify the labeled and delimited output data.–L
Displays data in a readable format.–hr
Specify the host ID for which LUN information is displayed. The word "all" can be
used to indicate all hosts.
–ha <host ID>
Specify the address of a management station in the format <http://path.to.man-
agementstation/>.
–ms <URL>
Specify a user name and password pair in the format user name:password.–auth <user:passwd>
Specify the version number. Indicates how the data must be displayed. Currently
supported values are 010500, 010600, and 015100. The default value is
010500.
–dver <xxxxxx>
Specify the maximum number of records to return. You cannot specify a number
of records higher than 16000.
–mr <maxRecords>
Specify the RAID Group for which you want the output displayed.
The word "all" can be used to indicate all hosts. Not adding this switch has the
same effect.
–rg <raidGroup>
Specify the CHP port for which you want the output displayed.
The word "all" can be used to indicate all hosts. Not adding this switch has the
same effect.
–chp <chpPort>
CLUI commands20