PCI-to-Fibre Channel Host Bus Adapter for IBM AIX - Installation Guide

Maintenance and Troubleshooting 3–3
Serial Number 642
Displayable Message Cambex Fibre Channel I/O
Controller
Network Address 500502E01000082
Device Specific (ZO) Build: MFtl
Device Specific (YL) P2-I2/Z1
cfgmgr -v >/tmp/cfg.log
2>&1
Should identify the card and configure it.
If cfg.log contains the ID 77100021 and no driver is found, then
the driver is not installed.
If an MCA card is present but not configured, then check for and
remove the reset jumper on the card.
lsattr -El scsi<x> for each <x> device should give:
id 0 Adapter card SCSI ID True
Make sure that the ID value does not conflict with any other host or device on the same Fibre
Channel loop. The other attributes will be different on each card.
During boot, the number displayed when configuring the adapter is 0x911 (FC adapter).
/usr/lpp/cbxfc/mbtest
scsi<x>
This test code may be used to get the Fibre Channel status from
the adapter or from attached devices. Type mbtest -help for more
information about how to use this command.
/usr/lpp/cbxfc/sctest
scsi<x>
This test code maybe used to get IOCINFO information from the
adapter, or to see the results of SCSI Inquiry or TestUnitReady
commands to SCSI devices attached to the adapter. Type sctest
-help for more information about how to use this command.
/usr/lpp/cbxfc/runtrace This should be run to start a trace if Cambex support requests a
trace of the card failure. To stop the trace and generate a trace
report, enter:
trcstop; trcrpt >
/tmp/trc.log
Table 3–1 Installation Problems (Continued)