PCI-to-Fibre Channel Host Bus Adapter for IBM AIX - Installation Guide

3–2 Compaq StorageWorks PCI-to-Fibre Channel Host Bus Adpater for IBM AIX Installation Guide
Checklist for Driver and HBA Installation
The commands listed in Table 3–1 may be used to isolate problems during installation of
the Fibre Channel driver and card. Type the command shown in bold and verify the output.
Table 3–1 Installation Problems
Command Output
whoami must be root
uname -a must give 5 fields:
‘AIX’
hostname where card is installed
1 or higher as minor rev of AIX
4 as version of AIX
serial number of host
lslpp - l PC1000.driver.obj must give:
Fileset Path:/usr/lib/objrepos PC1000.driver.obj
Level 01.05.00.00 or (greater)
State Committed
lsdev -Cc adapter should print line for each card:
scsi<x> <x> is a unique number for
each SCSI card
Available <SS-SS> <S> is the location in the
machine where the card is
installed
Check that the number of SCSI cards and their slots are correct.
If ‘Available’ then card and driver are installed.
If ‘Defined’ or not listed then card was not found.
lscfg -vl scsi4 should print more information for a card:
Device Location Description
scsi2 20-60 Cambex Fibre Channel
I/O Controller
Manufacturer Cambex
Machine Type and Model PC1000F
ROS Level and ID V2.01.19