HP StorageWorks Network Storage Router M2402 V1.0 User Guide (March 2004)

Configuration Overview
54 Network Storage Router M2402 User Guide
Router Default Settings
Some of the basic factory default values are:
■ IP address: http://1.1.1.1/
■ Subnet mask: 255.255.255.0
■ Gateway address: 0.0.0.0
■ User name: root
■ Password: password
HP recommends these values be changed from the defaults.
All settings within the router configuration are pre-set with default values. These
values are set to allow the router to be installed into most HP environments with
little or no configuration changes.
After changing the basic default values listed above, carefully consider any
additional configuration changes.
After the initial configuration of the router is established, HP recommends
backing up the configuration to an external file. If needed, during a recovery
process, this file can then be restored back onto the router.