hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Removal and Replacement Procedures
77NAS e7000 v2 Maintenance and Service Guide
Figure 53: Unscrewing the thumbscrews and sliding the system board
Note: When handling the system board, place your hands only on the two handles.
15. Grasping the two handles, lift the side with the processor handles first, tilting the board to
a 45° angle (1).
16. Lift the entire system board out of the chassis (2).
17. Transfer the processors and PPMs to the replacement system board. Be sure to put them
back in the same slots.
18. Check the SW4, SW7, and SW8 switch settings on the old board against the settings in
chapter 4 to be sure that they are in the correct positions.
Figure 54: Removing the system board from the chassis
1
3
3
2
1
2