hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Removal and Replacement Procedures
64 NAS e7000 v2 Maintenance and Service Guide
Figure 39: Removing the processor/heatsink assembly
Reverse steps 1 through 7 to replace a processor.
Caution: The processor is designed to fit one way into the socket. Align the three holes in
the base of the heatsink with the three positioning pins in the retaining bracket to properly
seat the processor.
Note: Mixing processor speeds and cache sizes is not supported.
Caution: Before closing the processor retaining bracket, be sure that the processor locking
lever is closed. Forcing the bracket shut may damage the processor or the processor socket.
Non-Hot-Plug PCI-X Expansion Boards
To remove a non-hot-plug expansion board:
1. Power down the server. Refer to “Powering Down the Server” in this chapter.
2. Extend the server from the rack. Refer to “Extending the Rack from the Server” in this
chapter.
3. Open the rear access panel. Refer to “Opening and Removing the Rear Access Panel” in
this chapter.
4. Disconnect any cables connected to the expansion board.
5. Press the PCI-X retaining clip until it stays in the open position.
1
2