hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Removal and Replacement Procedures
63NAS e7000 v2 Maintenance and Service Guide
Processors
To remove a processor:
1. Power down the server. Refer to “Powering Down the Server” in this chapter.
2. Extend the server from the rack. Refer to “Extending the Rack from the Server” in this
chapter.
3. Open the rear access panel. Refer to “Opening and Removing the Rear Access Panel” in
this chapter.
4. Remove the processor air baffle. Refer to “Processor Air Baffle” in this chapter.
5. Loosen the thumbscrew on the processor retaining bracket (1).
6. Open the processor retaining bracket (2).
Figure 38: Opening the processor retaining bracket
7. Remove the PPM. Refer to “Processor Power Modules (PPMs)” in this chapter.
8. Move the processor-locking lever to the unlocked position (1).
9. Lift the processor/heatsink assembly straight up from its socket (2).
1
2