hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Removal and Replacement Procedures
60 NAS e7000 v2 Maintenance and Service Guide
Power Button/LED assembly
To remove the power button/LED assembly:
1. Power down the server. Refer to “Powering Down the Server” in this chapter.
2. Extend the server from the rack. Refer to “Extending the Rack from the Server” in this
chapter.
3. Remove the rear access panel. Refer to “Opening and Removing the Rear Access Panel”
in this chapter.
4. Remove the front access panel. Refer to “Removing the Front Access Panel” in this
chapter.
5. Unplug the cable from the removable media board (1).
6. Push on the locking tab until the opposite side comes out (2).
Figure 34: Removing the power button/LED assembly
Reverse steps 1 through 6 to replace the power button/LED assembly.
Processor Air Baffle
To remove the processor air baffle:
1. Power down the server. Refer to “Powering Down the Server” in this chapter.
2. Extend the server from the rack. Refer to “Extending the Rack from the Server” in this
chapter.
3. Open the rear access panel. Refer to “Opening and Removing the Rear Access Panel” in
this chapter.
4. Remove memory board 1. Refer to “Removing a Memory Board” in this chapter.
5. Squeeze both ends of the baffle to release the tabs (1).
6. Lift the processor air baffle from the chassis (2).
1
2