hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Removal and Replacement Procedures

52 NAS e7000 v2 Maintenance and Service Guide

■ The PCI-X Hot Plug button and the PCI-X Hot Plug Utility enable you to power up or

power down a PCI-X Hot Plug expansion slot. The PCI-X Hot Plug button enables direct

access at each hot-plug expansion slot.

■ PCI-X Hot Plug software support for each operating system is available online. For more

information, refer to the PCI Hot Plug Administrator’s Guide on the Documentation CD.

The NAS e7000 v2 includes six PCI-X expansion slots. Use Figure 26 and Table 12 to identify

each slot.

Figure 26: PCI-X slot locations

To remove an expansion board from a PCI-X Hot Plug slot:

1. Extend the server from the rack. Refer to “Extending the Server from the Rack” in this

chapter.

2. Open the rear access panel. Refer to “Opening and Removing the Rear Access Panel” in

this chapter.

3. Press the port-colored PCI-X Hot Plug button (1) to turn off power to the slot. The power

LED flashes until shutdown is complete. Refer to “PCI-X Hot Plug LEDs” in Chapter 4 to

determine the current PCI-X Hot Plug slot status.

Table 12: NAS e7000 v2 PCI-X Expansion Slots and Buses

Item Description Bus

1 Slot 1 (non-hot-plug)

Shared bus 2

2 Slot 2 (non-hot-plug)

3 Slot 3 (hot-plug)

Shared bus 6

4 Slot 4 (hot-plug)

5 Slot 5 (hot-plug)

Shared bus 10

6 Slot 6 (hot-plug)