hp StorageWorks NAS e7000 v2 Maintenance and Service Guide

Connectors, LEDs, and Switches

112 NAS e7000 v2 Maintenance and Service Guide

Enabling ROMPaq Disaster Recovery Mode

A corrupted system ROM requires you to recreate the ROM BIOS by using the ROM flash

utility. This can be accomplished only when the system is in disaster recovery mode. Set

configuration switches 1, 4, 5, and 6 on the system maintenance switch block to on to enable

disaster recovery mode.

Note: Before enabling ROMPaq disaster recovery mode, refer to the

Servers Troubleshooting Guide

for complete instructions on disaster recovery.

System ID Switch (SW7)

Figure 76 and Table 34 identify the system ID switch location and settings.

Figure 76: System ID switch (SW7)

Table 34: System ID Switch (SW7)

Position Default Function Description Settings

1 through 3 Chassis ID Used to allow 8 ID

combinations, if used as

another system.

321