NAS b3000 v2 - Quick Start Guide (326190-002)

Configuration Setup
46 NAS b3000 v2 Quick Start Guide
3. Go to the NAS device and power it on. It will be several minutes before the
NAS device is accessible on the network.
4. Open Internet Explorer on the Windows-based PC. Enter
http://, the serial
number of the NAS b3000 v2 followed by a hyphen (
-), followed by :3201.
Press Enter. This launches the WebUI configuration application (Rapid
Startup) on the target HP StorageWorks NAS device as shown in Figure 9.
Example:
http://D4059ABC3433-:3201
Note: The NAS device will respond when the NAS operating system has started.
5. Using the information from Table 3, fill in the screens that follow. Verify that
your information is correct when the configuration review screen is displayed,
as shown in Figure 10. Online help is available for all pages by clicking the
“?” in the right side of the Web UI.
6. Click the Finish icon to complete Rapid Startup. If a reboot is required, Rapid
Startup will present a message that a reboot is occuring.
7. The browser will refresh to the status page of the NAS device. The refresh
may take several minutes if the device was restarted. Click on the HP utilities
tab and select the SAN Connection Tool. Do not connect storage until
instructed to do so by the tool.
8. For cluster deployments only, repeat steps 3 - 7 with the second node. After
the second node is configured, follow the online Cluster Install Guide found in
the Cluster tab of the Web UI. Additional information can also be found in
Chapter 4 of this document as well as the cluster section of the administration
guide.