NAS b3000 v2 - Quick Start Guide (326190-002)

Configuration Setup
39NAS b3000 v2 Quick Start Guide
Procedure
To initialize the NAS b3000 v2 using the WebUI configuration application:
Caution: Do not power up the NAS device until steps 1 through 6 are
completed.
1. Connect the Ethernet cables to the respective network ports of the
NAS b3000 v2 and the corresponding network segments, in accordance with
the information in the “Configuration Information” section in Chapter 2.
2. See Figure 6 and Table 3 for the locations of the network ports on the
NAS b3000 v2.
Figure 6: Ethernet connectors
3. Verify that the Windows-based PC client is connected to the same subnet as
the NAS b3000 v2.
Table 3: Ethernet Network Connectors
Item Description
1 Integrated Lights-Out Ethernet port (iLO Eth)
2 NIC Ethernet port 1 (Eth 1) used for data or cluster heartbeat
3 NIC Ethernet port 0 (Eth 0) used for data
31 2