HP StorageWorks SAN Switch Rack Mount Kit Installation Instructions (AV-RU6YD-TE, September 2004)

13SAN Switch Rack Mount Kit Installation Instructions
5. The SAN Switch Rack Mount Kit provides different screw types for securing
the inner rails. Specific devices require a different number of these screws.
Determine the number of screws to attach the inner rails to the device as
follows:
Caution: Do not use any other screws other than the ones provided. Use of
any longer lengths can cause damage to internal components.
a. For the SAN Switch 2/8V, SAN Switch 2/16, SAN Switch 2/16V, SAN
Switch 2/16N or MP Router models, locate ten # 8-32 x 5/16-inch Phillips
pan-head SEMS screws to secure the inner rails (five screws per rail).
b. For the MP Router models, locate six # 8-32 x 5/16-inch Phillips
pan-head SEMS screws to secure the inner rails (three screws per rail).
c. For the SAN Switch 2/32, locate twelve #8-32 x 3/16-inch Phillips
pan-head screws with thread lock to secure the inner rails (six screws per
rail).
6. Identify the screw holes on the inner rails for your specific device. The screw
holes are labelled as follows:
a. To attach the inner rails to the SAN Switch 2/8V, SAN Switch 2/16V or
SAN Switch 2/16N use the screw holes marked 8
b. To attach the inner rails to the SAN Switch 2/32 use the screw holes
marked 32
c. To attach the inner rails to the MP Router, use the screw holes marked R
Note: Remember to use the screw holes labelled 8 when attaching the inner rails to the
SAN Switch 2/16V or SAN Switch 2/16N. DO NOT use the screw holes labelled 16.
7. Assemble the two inner rails (one on each side) to the device using the
appropriate number of screws (refer to step 5).
For example, Figure 6 shows an inner rail attached to the SAN Switch 2/16V
with five screws. Attaching both rails requires ten screws.
Also, Figure 7 shows an inner rail being attached to the MP Router with three
screws. Attaching both rails requires six screws.