HP StorageWorks XPath OS 7.4.X System Error Messages Reference Guide (AA-RVHGC-TE, September 2005)

XPath OS 7.4.x system error messages reference guide 81
Fabric Control Daemon messages
This section describes the Fabric Control Daemon (FAB) system error messages.
FAB-CHA-ERR
Message
Probable cause
A fabric change error occurred. This condition is usually transitory.
Recommended action
Reboot or power cycle the MP Router.
Severity
Error
FAB-CSCN-ERR, fabctl: could not open wka driver
Message
Probable cause
The WKA (well-known address) driver file is not available.
Recommended action
Reboot or power cycle the MP Router.
Severity
Critical
FAB-CSCN-ERR, fabctl: could not open xbar control Q
Message
Probable cause
A CSCN connection to xbar Control Q failed. Port-to-CM (port management frames) traffic that does not
have an FC header is categorized as a Control Q frame.
Recommended action
Reboot or power cycle the MP Router.
Severity
Critical
process_id (fabctl): date time
Error FAB-CHA-ERR, 2, fabctl: Saved objid failed. Aborting save.
process_id (fabctl): date time
Critical FAB-CSCN-ERR, 1, fabctl: could not open wka driver
process_id (fabctl): date time
Critical FAB-CSCN-ERR, 1, fabctl: could not open xbar control Q