HP StorageWorks XPath OS 7.4.X System Error Messages Reference Guide (AA-RVHGC-TE, September 2005)

XPath OS 7.4.x system error messages reference guide 59
CM-EVENT_SFP_REMOVED
Message
Probable cause
The SFP transceiver at port n was removed.
Recommended action
1. Check the SFP transceiver status using the sfpShow command.
2. Replace any missing SFP transceivers.
3. Verify that the SFP transceiver is seated correctly.
4. Check for faulty cables, deteriorated SFP transceivers, or dirty connections.
5. Replace the cables and SFP transceivers if necessary.
Severity
Warning
CM-EVENT_SHUTDOWN_TEMP_EXCEEDED
Message
Probable cause
The shutdown temperature limit has been exceeded. The switch automatically initiates a shutdown.
Temperature problems usually indicate either defective fans or environmental temperature problems.
Recommended action
1. Verify or perform immediate shutdown of the switch.
Excessive temperatures can damage the MP Router. Wait for the switch to cool before rebooting and
running diagnostic commands.
2. Use the tempShow command to view the temperature of the MP Router.
3. Use the fanShow command to verify that the fans are operating properly.
4. Replace any defective fans.
5. Verify that the room temperature is within the operational range.
See the installation guide for your switch for details about the operational temperature range.
Severity
Error
process_id (EvtMgr): date time
Warning CM-EVENT_SFP_REMOVED, 3, An SFP has been removed at port n
process_id (EvtMgr): date time
Error CM-EVENT_SHUTDOWN_TEMP_EXCEEDED, 2, Shutdown temperature exceeded, card n
sensor s temp temp