HP StorageWorks XPath OS 7.4.X Command Reference Guide (AA-RVHCC-TE, September 2005)

62 XPath OS CLI commands
Sets or displays diagnostic power-on self-test (POST) configuration.
Synopsis
diagpost [mode]
Availability
admin
Description
This command enables and disables POST. For Post to run, the MP Router must be rebooted after enabling
POST.
NOTE: By default, POST is enabled.
Operands
This command has the following operand:
Examples
To enable POST:
See also
diagDisablePost
diagEnablePost
diagPost
mode Specifies the mode as 1 (enabled) or 0 (disabled). If a mode is
not specified, the currently set mode is displayed.
switch:admin> diagpost 1